Intelligent Fastener - Changelog

6.0.1.1

Enhancements

• Introduce new setup for IFX. [RM-7500]
• allow different param_relations.txt in ifx_fastener_data folder. You can add a suffix for your catalog or for the fastener type (screws, nuts, washers, pins or insters). Example: 'param_relations_screws.txt' or 'param_relations_mm.txt' or even both param_relations_mm_screws.txt. NOTE: The catalog has higher priority. [RM-7212]

Improvements

• User must select the param_relations*.txt file while create instance process if more than one file exist. [RM-7778]

Bugfixes

• Fix problem with nonsynchronous hole files. Allow blanks in THREAD_SERIES now. [RM-7639]
• Fix problem while converting the library to the new file structure. The param_relations.txt was not converted. If different param_relations.txt files are used, the new naming scheme is used. [RM-7777][RM-5860]

6.0.1.0

Enhancements

• Introduce new mechanism for IFX configuration files. [RM-7211]

Bugfixes

• Fix problem with mapkey to reset hole. The mapkey was only execuded for Creo 1.0 up to Creo 3.0. [RM-7612]

6.0.0.0

Enhancements

• Add IFX commands to minitoolbar. [RM-6133]
• Check Reference for existing Fasteners. [RM-6085]