Intelligent Fastener - Changelog

6.0.3.3

Bugfixes

• Fix problem with active models. If a part was activated, the IFX-commands where still available. IFX-commands only enabled for assemblies now. [RM-9189]

6.0.3.2

Improvements

• Use new hidden option 'REGENERATE_INSTANCE' to regenerate a new fastener instance a second time.

6.0.3.0

Bugfixes

• Fix problem with 'Current Session'. If the 'Directory' in the 'Intelligent Fastener Options' dialog is set to 'Current Session', the *.cfg files cannot be found. The files are now loaded from the last selected configuration directory. [RM-8770]

6.0.2.0

Enhancements

• Allow usage of differnent tables in ifx_screw_data.cfg and ifx_pin_data.cfg (e.g. use different #MUSCR values for different DAT files). [RM-8217][SPR-8257948]
• Allow to enter a name for SURFACE, AXIS and ORIENT. It is also possible to add the columns #SURFACE, #AXIS and #ORIENT. This enables you to use different assembly references for each instance. This is importand if you use different legacy data in one fastener data file (*.dat). [RM-6636]

Bugfixes

• Fix problem with SCR_COLOR_THREAD. [RM-8241][SPR Task-8356598]

6.0.1.1

Enhancements

• Introduce new setup for IFX. [RM-7500]
• allow different param_relations.txt in ifx_fastener_data folder. You can add a suffix for your catalog or for the fastener type (screws, nuts, washers, pins or insters). Example: 'param_relations_screws.txt' or 'param_relations_mm.txt' or even both param_relations_mm_screws.txt. NOTE: The catalog has higher priority. [RM-7212]

Improvements

• User must select the param_relations*.txt file while create instance process if more than one file exist. [RM-7778]

Bugfixes

• Fix problem with nonsynchronous hole files. Allow blanks in THREAD_SERIES now. [RM-7639]
• Fix problem while converting the library to the new file structure. The param_relations.txt was not converted. If different param_relations.txt files are used, the new naming scheme is used. [RM-7777][RM-5860]

6.0.1.0

Enhancements

• Introduce new mechanism for IFX configuration files. [RM-7211]

Bugfixes

• Fix problem with mapkey to reset hole. The mapkey was only execuded for Creo 1.0 up to Creo 3.0. [RM-7612]

6.0.0.0

Enhancements

• Add IFX commands to minitoolbar. [RM-6133]
• Check Reference for existing Fasteners. [RM-6085]