Changelog
7.0.3.1
Bugfixes
- Fix problem with offset '-0.1' for screw-in connections. [RM-11174]
7.0.3.0
Enhancements
- Hole file selection. Allow selection of hole file if more than one is available. [RM-5255]
- Add new screw options for clearance hole to control the diameter. [RM-5255]
CLEARANCE_HOLE_USE_LIMITS - Set limits for min. and max. clearance hole diameter.
CLEARANCE_HOLE_DIAMETER_OVERRIDE - Allow specifying the clearance hole value instead of the standard value.
Improvements
- Support of special character for THREAD_NAME or THREAD_SERIES in creo hole chats. [RM-10498][SPR-11163572][SPR Task-11163573]
Bugfixes
- The automatic length of the screws was not correct for prevailing torque type hexagon nuts. For NUTTYPE 50 and NUTTYPE 60 the L1 value is now used for autolength calculation. [RM-10462][SPR-11169725][SPR Task-11169728]
7.0.2.0
Enhancements
- Add new Option PATTERN_OPTION to control the pattern behavior for fasteners. [RM-9490][RM-9581]
Improvements
- Improve the creation time of new fasteners [RM-10070][RM-10072]
- Show error image if a part cannot be modified. In this case no holes are created by default. The user can change this in the 'Additional Options' dialog. [RM-9390][RM-9584]
- The creo option 'drilled_hole_tip_angle' can be used to control the tip angle of drilled holes now. The default value is 118° if the option is not set. [RM-8281]
Bugfixes
- Fix problem. IFX run into a problem in 'Additional Options' dialog. While searching for locked part a value was assigned to an invalid pointer.
7.0.1.0
Improvements
- Add What's New Dialog. [RM-9669]
Bugfixes
- Problems with 'SUBINFO' for family table dowel pins fixed. [RM-9644]
- Fix the 31 character limit for file name. [RM-9677][SPR-10054607]
- Fix problem if name for reference is longer than 80 signs. [RM-9920]
7.0.0.0
Enhancements
- Creo 7.0 ready version.
- Multibody support.
- Minitoolbar support.
- Enhance usage of ifx_screw_data.cfg and ifx_pin_data.cfg files.
- Enhance definition of placement references in Fastener Data Files.
- Enhance usage of relations.