Changelog
8.0.0.0
Enhancements
- Creo 8.0 ready version.
- Add new screw options for clearance hole to control the diameter. [RM-5255]
CLEARANCE_HOLE_USE_LIMITS - Set limits for min. and max. clearance hole diameter.
CLEARANCE_HOLE_DIAMETER_OVERRIDE - Allows specifying the clreance hole value instead of the standard value.
- Hole file selection. Allow selection of hole file if more than one is available. [RM-5255]
- Support embedded components. [RM-9979][RM-10288][RM-10349]
- Support new hole creation on sketch as a pattern reference for fasteners. [RM-10206][SPR-10182114]
- Add new Option PATTERN_OPTION to control the pattern behavior for fasteners. [RM-9490][RM-9581]
Improvements
- Support of special character for THREAD_NAME or THREAD_SERIES in creo hole chats. [RM-10498][SPR-11163572][SPR Task-11163574]
- Improve the creation time of new fasteners [RM-10070][RM-10072]
- Show error image if a part cannot be modified. In this case no holes are created by default. The user can change this in the 'Additional Options' dialog. [RM-9390][RM-9584]
- The creo option 'drilled_hole_tip_angle' can be used to control the tip angle of drilled holes now. The default value is 118° if the option is not set. [RM-8281]
- Add What's New Dialog. [RM-9669]
Bugfixes
- The automatic length of the screws was not correct for prevailing torque type hexagon nuts. For NUTTYPE 50 and NUTTYPE 60 the L1 value is now used for autolength calculation. [RM-10463][SPR-11169725][SPR Task-11169729]
- Fix problem. IFX run into a problem in 'Additional Options' dialog. While searching for locked part a value was assigned to an invalid pointer.
- Problems with 'SUBINFO' for family table dowel pins fixed. [RM-9644]
- Fix the 31 character limit for file name. [RM-9677][SPR-10054607]
- Fix problem if name for reference is longer than 80 signs. [RM-9920]